QUICK START

1

START

2

PROGRAM

: ON
1 sec : OFF

: Change program

ICON

ICON X

Bottle Caps & large ferrous

Beach & Surf
Wet Beach
Park
Forest
Trashy Field
Field

Notch bar

Target conductivity scale

Factory programs

USB-C port access:
Hold to unlock + pull cap gently

*

SELECTED SETTING
Blinking = Bottom line

*This program differs on ICON and ICON X.

Change program
3 sec: Save

PAIRING

Press  until , then hold  1 sec

Hold  8 sec

In case of a “KO” message, scan the QRcode and update your ICON / headphones to the same version.

| Speaker volume
+ | Headphones volume
| Backlight
| Update
| Go Terrain mobile App
| Wireless headphones pairing
| MI-6 pairing
| Coil selection + pairing

OPTIONS

Target depth gauge

ON
1 sec : OFF
All-metal mode

OPTIONS
1 sec in OPTIONS: Expert

SENSITIVITY - Adjust value

VALIDATE - Hold: GRAB the ground value

Shortcuts (long press)
| Frequency Scan
| Pinpoint

SETTINGS
1 sec in SETTINGS: Expert

DECLARATION OF COMPLIANCE EU - FCC - IC - UKCA

SAFETY/RECYCLING/PRECAUTIONS

This declaration is made under the responsibility of the manufacturer :
SARL XPLORER - 8 rue du Développement – F-31320 CASTANET-TOLOSAN
We, XPLORER, hereby certify that this detector complies with the essential requirements of European Directives RED 2014/53/EU, SECURITY 2014/35/EU and EMC 2014/30/EU which aim to harmonize legislation in Member States on the use of the radio spectrum, electromagnetic compatibility and electrical safety. The device's compliance was assessed in accordance with the essential requirements of this Directive and the harmonized standards:
• EMF: EN 62311 :2008
• DETECTION EU: ETSI EN 303454 V1.1.1
• RADIO EU: EN 300440 v2.1.1 ; ETSI EG 203367 V1.1.1
• RADIO USA: FCC 47 CFR part 15: 2019
• RADIO CANADA: RSS-210_Issue 9: 08/2016 (Amended 2017)
• SAFETY: IEC 60950-1: 12/2005/AC1: 2006/A1: 2009/A2: 2013; IEC 62368-1: 2014
• EMC: ETSI EN 301489-1:2019 V2.2.3;ETSI EN 301489-9: 2019 V2.1.1; Draft ETSI EN 301489-17: 2019 V3.2.2
A copy of the certificate can be supplied upon request from:
SARL XPLORER - 8 rue du Développement – F-31320 CASTANET-TOLOSAN
FCC: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
NOTE: The grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. Such modifications could void the user’s authority to operate the equipment.
IC : This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

Safety precautions

Acceptable ambient temperature during charging:  From 0°C to + 40°C maximum.
Recommended storage temperature: 25°C.
Batteries:
• The batteries are fitted with internal protection systems which shield them from extreme overloads and discharges. They must not be dismantled or short-circuited, which is dangerous and could destroy the protection systems, explode or cause the batteries to ignite.
• Do not leave batteries on charge unnecessarily and disconnect the power adaptor when the charge cycle is complete or after 3 hrs.
• If you notice any perforation, odour or other anomaly, please return the battery to the retailer in a sealed plastic bag and do not try to charge again (risk of destroying the protection systems, explosion or causing the batteries to ignite).
• Never dispose of lithium batteries with your household waste: return them to your XP retailer or take them to a designated collection point.
• Do not place the batteries near heat sources and never throw them onto a fire.
• Never perforate the battery cover or try to weld/solder the battery.
• Risk off explosion if battery is incorrectly replaced. Replacing the battery with another of the incorrect type can lead to a risk of explosion. Only use LiPo batteries supplied by XP (For the ICON RC ref.: D2-BAT-G0-002).
• If you notice abnormal overheating of components on charge, disconnect the mains unit immediately and do not try to charge further.
BATTERY REPLACEMENT (ref XP : IC-D28-F0-001) : The search coil battery is sealed for obvious reasons - safety and impermeability. It must be returned to our service department or an XP distributor for replacement.

Recycling of electrical and electronic waste in the European Union and the other
countries/regions in accordance with selective waste sorting procedures

If this symbol is displayed on the product or its packaging, it means that the product must not be disposed of with your household waste. It must be taken to a designated collection point for recycling electrical and electronic waste. This selective waste sorting and recycling helps to preserve natural resources and avoid any potential risks for human health and the environment that could result from inappropriate scrapping, due to the possible presence of hazardous substances in the electric and electronic equipment. For more information on places for disposing of electrical waste, please contact the shop where you purchased this product. Alternatively you can return it to your supplier, or directly to XP. The same is true for the lithium batteries which must be recycled appropriately.
© 2026 sarl Xplorer
This document contains information that is protected by existing legislation on copyright, brands and royalties. Any reproduction, even partial, of this document, the logos or the XP and Dēus brands is prohibited without the consent of:
SARL XPLORER - 8 rue du Développement – F-31320 CASTANET-TOLOSAN

www.xpmetaldetectors.com

GB

C00DBF

After Diving, dry the cap before closing!

Underwater use: BH-02* bone conduction headphones required. Without it, IP68 - 1.5m (5ft) with remote cap closed.

USE IN WATER

QUICK START GUIDE

*BH-02, accessory not included

Charging time | 3 h
Battery life | 11 h
LED charging | Steady
End of charge | 4 sec On - 4 sec Off
Standby | 1 flash every 4 sec

Waveguide installation

Activate the free 5-year warranty for your detector or upgrade to 10 years.

4

3

Download our free Go Terrain app to record all your activities.

Full manual

Retrouvez ce manuel sur l’application Go Terrain téléchargeable ici : QR Code

To locate a target, note where the sound is strongest. Turn 90° and sweep again.

Sweep left to right, parallel to the ground, as close to the surface as possible without touching it.

HINTS & TIPS

ASSEMBLY & CHARGING